JP Cabinet

OVERVIEW

Outdoors integrated distribution cabinet series is suitable folAC 50 Hz, rated voltage up to 0.4 kV power transmission anddistributon system. This series of product is a combinationofautomatic compensation and power distribution. And it isa innovative indoors and outdoors pressure distributioncabinet of electrical leakage protection, energy meteringover-current,over-pressure open phase protection. lt hasbenefits of small volume,easy installation, low cost

electricity-stolen prevention, strong adaptability, resistancto aging,accurate rotor, no compensation error, etcTherefore it is the ideal and preferred product for electricgrid reformation.

PRODUCT SHELL

The product is made of bending and welding of high quality stainless steel. Compared with other distribution boxes made of cold steel, its tensile ability, oxidation resistance, corrosion resistance has been greatly strengthened, and it extends the service life of the equipment. Novel design shows scientific innovation and achievements. On the other hand, v-type box is equipped with sealing rubber strip, which can prevent the dust, and it is fitted with floor at the same time. It can be installed electrical equipment. The open angle is greater than 90 degrees. It is adopted the new design: waterproof, anti-theft, anti-dust. And organic glass has been adopted to increase safety, easily installation and operation. Specification

TECHNICAL REQUIREMENT

For dimensions, please refer to the actual dimensions of American style substationsThe concrete foundation should have a flat surface, and American style substations should be fixed on the foundation using pres

sure plates;The form of grounding, bars and cable fixing brackets can be determined according to the actual situationCable fixing brackets and grounding bars should be pre embedded;The position of cable holes for incoming and outgoing lines depends on the specific situationAfter the installation of American style substations, there must be a gap of no less than 1.5m on the front ofthe switch for easy operation;

The grounding grid can be made of 12 galvanized round steel or 40x4 galvanized flat copper, and the grounding resistance shouldmeet the requirements of the power department.

TINSTALLATIONDIMENSIONS

Scan and view on your phone

35KV

S10-M

S(B)H15-M

Electromagnetic wire

微信扫一扫：分享